Filter
Top Products
A-7
INSTALLATION
A-7
CONNECTION TO MILLER FEEDERS
Gun and cable assemblies which were assembled
with a K466-3 Connector Kit will connect easily to a
variety of popular Miller wire feeders.
a. Check that the gun liner, connector cap liner, drive
rolls and guide tubes are appropriate for the elec-
trode size being used.
b. Fully push the brass connector end of the gun and
cable into the connector receptacle on the outgoing
side of the feeder wire drive. Tighten the hand
screw to clamp down on the connector.
c. Insert the control cable plug into the mating socket
on the wire feeder.
CONNECTION TO HOBART 2000 FEEDERS
Gun and cable assemblies which were assembled
with a K466-7 Connector Kit will connect easily to a
variety of Hobart wire feeders.
a. Check that the adapter and feeder outgoing guide,
as well as the drive roll, are appropriate for the
electrode size being used.
b. Fully push the brass connector end of the gun
cable into the outgoing side of the feeder wire
drive. Secure the cable using the hand screw on
the wire feeder.
c. Connect the control cable plug into the mating
socket on the wire feeder.
CONNECTION TO LINCOLN -10 SERIES FEEDERS
Gun cable assemblies which were assembled with a
K466-10 Connection Kit or K471-21 thru -23 gun and
cable assemblies will connect easily to a -10 Series
feeder.
a. Check that the K1500-2 gun adapter is in place on
the wire feeder. Check that the feeder guide tubes,
as well as the drive roll(s), are appropriate for the
electrode size being used.
b. Fully push the brass connector end of the gun
cable into the gun adapter on the outgoing side of
the feeder wire drive and secure the cable using
the hand screw.
c. Insert the control cable plug into the mating socket
on the wire feeder.
MAGNUM® 400 DUAL PROCEDURE GUNS