Filter
Top Products
3. Place electrodes on the skin
Place the electrodes on the skin as recommended by your clinician.
4. Insert the Lead Wire Connector to the TENS device
Plug the end of the lead wire into the lead connector port to be used,
pushing plug in as far as it will go.
5. Select Treatment Settings
Ensure the unit is set to the proper settings (Pulse Width, Pulse Rate,
and Mode Selector), recommended by your physician.
6. Adjusting Channel Intensity Control
Locate the intensity control knob at the top of the unit. Turn channel 1 or 2
clockwise. The indicator light will light up when unit is in operation. Slowly
turn the channel control in a clockwise direction until you reach the intensity
recommended by your medical professional. Repeat for the other channel if
both channels are to be used.
If the stimulation levels are uncomfortable or become uncomfortable, reduce
the stimulation amplitude to a comfortable level or cease stimulation and
contact your physician.
BATTERY INFORMATION
When the yellow indicator light located on the front of the unit will no longer
light, the battery has become too weak to power the unit and it is time to
replace the battery. At this point the unit will shut off until the battery is
replaced. Dispose of the old battery according to local guidelines and
regulations.
07