Lumiscope sw-1000 Sander User Manual


 
TROUBLESHOOTING
If the TENS device does not function properly:
1. Make sure the battery is properly installed or replace the battery. Be sure
to observe proper polarity markings when replacing the battery. If the yellow
light on the front of the unit does not stay lit when the unit is turned on,
replace the battery and check again.
2. If the ON/OFF Indicator Light is flashing and no stimulation is felt, check
to ensure lead wires are properly connected and the electrodes are in place.
If the unit appears to be functioning and no stimulation is felt, the lead wires
or electrodes may need to be replaced.
3. If the battery appears to be charged and the unit is not functioning, turn
both lntensity Control Knobs to the OFF position(counter clockwise). Then
gradually turn the lntensity Control Knob to the on position.
If any other problems occur, contact an authorized GF Health Products, Inc.
distributor. Do not try to repair a defective device.
WARRANTY
This TENS device carries three years warranty from the date of purchase.
The warranty applies to the TENS device and necessary parts and labor
relating thereto. GF Health Products, Inc. reserves the right to replace
or repair the unit at their discretion.
The warranty does not apply to damage resulting from failure to follow the
operating instructions, accidents, abuse, alteration or disassembly by unau-
thorized individuals.
SYSTEM COMPONENTS
Your TENS device may include the following components or accessories:
- TENS unit
- Electrodes
- Hard case
- Lead wires
- Battery
- Ope
ration Manual
09