Filter
Top Products
Mode Functions
Burst (B) releases individual bursts twice per second, pulse width is
adjustable and the pulse rate is set at 100Hz per second.
Continuous (C) stimulation is delivered continuously at the settings deter-
mined by intensity, rate, and width knobs.
Modulation (M) pulse width decreases the pulse width down to 60% of the
original width setting. This decreased pulse width is maintained for 1.5
seconds before returning to the original width setting, which is maintained for
3.5 seconds. The cycle is then repeated. The intensity and pulse rate are
adjustable.
ATTACHING THE LEAD WIRES
The lead wires provided with the TENS device insert into the ports located on
top of the unit. Holding the insulated portion of the connector, push the plug
end of the wire into one of the ports; one or two sets of the wires may be
used. After connecting the wires to the stimulator, attach each wire to an
electrode.
Lead wires provided with the TENS device are compliant with mandatory
compliance standards set forth by FDA.
WARNING: Never insert the plug of the lead wire into an AC power supply
socket. Personal injury and/or damage to the TENS unit could occur.
ELECTRODE SELECTION AND CARE
Use the electrodes as prescribed.
Follow application procedures outlined in electrode packaging to maintain
stimulation and prevent skin irritation. The electrode packaging provides
instructions for care, maintenance and proper storage of electrodes.
05
Caution: Use care when plugging and unplugging the wires. Pulling on the
lead wire may cause wire breakage.