Filter
Top Products
ADDITIONAL SAFETY RULES
1.
Rags, cloth, cord, string and the like should never be left around the work
2.
Avoid cutting nails. Inspect for and remove all nails from
the
workpiece be-
3.
Handle the blades very carefully.
4.
Be sure the blade installation bolts are securely tightened before operation.
5.
Hold the tool firmly with both hands.
6.
Keep hands away from rotating parts.
7.
Before using the
tool
on an actual workpiece, let
it
run for a while. Watch
for vibration or wobbling that could indicate poor installation or a poorly
balanced blade.
8.
Make sure the blade is not contacting the workpiece before the switch is
turned on.
9.
Wait until the blade attains full speed before cutting.
area.
fore operation.
IO.
Keep at least
200
mm
(8”)
away from the tool at all times.
11.
Always switch off and wait for the blades to come to a complete stop be-
12.
Never stick your finger into the chip chute. Chute may jam when cutting
13.
Do
not leave the tool running. Operate the tool only when hand-held.
14.
When leaving the planer, switch off and set
it
with the front base up on a
15.
Always change both blades or covers on the drum, otherwise the resulting
fore any adjusting.
damp wood. Clean out chips with a stick.
wooden block,
so
that the blades do not contact anything.
imbalance will cause vibration and shorten tool life.
SAVE
THESE INSTRUCTIONS.
4