Filter
Top Products
First, loosen the two wing nuts on the
holder and insert the blades
(A)
and
(B)
so
that they contact the sides
(C)
and
(D).
Then tighten the wing nuts.
Immerse the dressing stone in water for
2
or
3
minutes before sharpening. Hold the
holder
so
that the blades both contact the
dressing stone for simultaneous sharpening
at
the same angle.
I
Wing
nut
Side
(C)
Fig.
1
Fig.
Id
MAINTENANCE
CAUTION
:
Always be sure that the tool is switched off and unplugged before attempting to perform
inspection
or
maintenance.
The tool will stop when the carbon brushes wear to
a
certain length. When this occurs,
both carbon brushes should be replaced.
To
maintain product SAFETY and RELIABILITY, repairs, carbon brush inspection and
replacement, any other maintenance or adjustment should be performed by Makita
Authorized or Factory Service Centers, always using Makita replacement parts.
9