Filter
Top Products
Align the blade edge with the mark and
make the drum stationary by means of the
stopper pin.
Place
the leveller over the rear
base and blade, and press the leveller down
slightly.
Release
the stopper pin.
Turn the drum in the direction of the
arrow
(Fig.
6)
to check the blade protru-
sion, holding the leveller flush against the
blade and rear base. The blade edge should
just contact the underside of the leveller.
When the blade edge does not protrude far
enough from the base, press down on the
pin in the middle of the drum with the
socket wrench handle, and adjust the
blades again
as
mentioned above. After
adjusting both blades, tighten the four in-
stallation bolts evenly and alternately with
the socket wrench.
Stopper pin
When released When secured
~
Fig.
4
I
Leveller
-
R
se
I
Fig.
CATU
ION
:
Tighten the blade installation bolts carefully when attaching the blades to the tool.
A
loose installation bolt can be dangerous. Always check to
see
they are tightened securely.
6