Filter
Top Products
7
NOTE:
• Use a dry cloth to wipe the dirt off the lens of light. Be
careful not to scratch the lens of light, or it may lower the
illumination.
ASSEMBLY
CAUTION:
• Always be sure that the tool is switched off and
unplugged before carrying out any work on the tool.
Installing or removing trimmer bit
CAUTION:
• Do not tighten the collet nut without inserting a bit, or the
collet cone will break.
• Use only the wrenches provided with the tool.
Insert the bit all the way into the collet cone and tighten the
collet nut securely with the two wrenches. To remove the bit,
follow the installation procedure in reverse.
OPERATION
Set the tool base on the workpiece to be cut without the bit
making any contact. Then turn the tool on and wait until the
bit attains full speed. Move the tool forward over the work-
piece surface, keeping the tool base flush and advancing
smoothly until the cutting is complete.
When doing edge cutting, the workpiece surface should be
on the left side of the bit in the feed direction.
1. Loosen
2. Tighten
3. Hold
1
2
3
001700
1. Workpiece 2. Bit revolving direction
3. Feed direction 4. View from the top of the tool
5. Correct bit feed direction 6. Bit revolving direction
7. Feed direction 8. Correct bit feed direction
1
2
3
4
5
6
7
8
001701