Filter
Top Products
9
Loosen the screws and remove the base protector. Place the
templet guide on the base and replace the base protector.
Then secure the base protector by tightening the screws.
Secure the templet to the workpiece. Place the tool on the
templet and move the tool with the templet guide sliding
along the side of the templet.
NOTE:
The workpiece will be cut a slightly different size from the
templet. Allow for the distance (X) between the router bit and
the outside of the templet guide. The distance (X) can be
calculated by using the following equation:
Distance (X) = (outside diameter of the templet guide - router
bit diameter) / 2
Straight guide (optional accessory)
The straight guide is effectively used for straight cuts when
chamfering or grooving.
1. Screws
2. Base protector
3. Screwdriver
11
2
3
001704
1. Base
2. Templet
3. Straight bit
4. Templet guide 10
5. Distance (X)
6. Workpiece
7. 10 mm (3/8”)
1
2
3
4
6
5
7
001705
001706