Filter
Top Products
12
min (11-13/16”/min).) Also slow down as you complete a cut
to avoid breaking or cracking the workpiece being cut.
CAUTION:
• Be sure to hold the workpiece firmly down on a stable
bench or table during operation.
• Do not twist or force the tool in the cut, or the motor may
be overloaded or the workpiece may break.
• Do not use the tool with the wheel in an upward or
sideways position.
• When cutting glass plate, it is recommended to attach a
rubber plate (optional accessory) on the base of the tool
to prevent the workpiece surface from being scratched.
• The wheel for this tool is a wet-type wheel for glass and
tile applications. Be sure to feed water to the wheel
during operation.
• If the cutting action of the wheel begins to diminish,
dress the cutting edge of the wheel using an old
discarded coarse grit bench grinder wheel or concrete
block. Dress by pressing lightly on the outer edge of the
wheel.
NOTE:
• If the tool is operated continuously until the battery
cartridge has discharged, allow the tool to rest for 15
minutes before proceeding with a fresh battery.
MAINTENANCE
CAUTION:
• Always be sure that the tool is switched off and the
battery cartridge is removed before attempting to
perform inspection or maintenance.
After use
Brush off accumulation of dust on the base.
To maintain product SAFETY and RELIABILITY, repairs, any
other maintenance or adjustment should be performed by
Makita Authorized or Factory Service Centers, always using
Makita replacement parts.
EN0001-1