Filter
Top Products
Charging
Uncap the charging connector hole.
Connect the charging plug to the charging
connector, then plug in the charger to the
power receptacle. Charging takes
3
hours.
CAUTION:
0
The battery in your new
tool
is not fully
charged. You will need
to
charge it
before use.
0
Do
not operate the
tool
during charging.
0
Overcharging more than
2
days
considerably shortens the battery service
life. Always unplug the charger after
completing the charge. Then cap the
charging connector hole.
0
When you charge a new tool or a tool which has not been used for a long period, it may
not accept a full charge. This is a normal condition and does not indicate a problem. You
can recharge the tool fully after discharging it almost completely a couple of times.
Nominal Diameter
(mm)
Bit
No.
Wood
Screw
2.1
-
2.7 (3132
-
1/8”)
No.
2
3.1 -4,5(1/8”-3/16)
Selecting correct
Phillips
bit
Use the chart to determine the best size
driver bit for the size of screw that you wish to
use.
Selecting slotted bit
Use a slotted bit that properly fits the screw
slot. Use of a bit that is too small will damage
the screw and/or bit.
6