Filter
Top Products
Installing
or
removing battery cartridge
0
Always switch
off
the
tool
before insertion or removal
of
the battery cartridge.
0
To
remove the battery cartridge, pull
out
the set plate on the
tool
and grasp both
sides
of
the cartridge while withdrawing
it
from the barrel.
0
To
insert the battery cartridge, align the
tongue
on
the battery cartridge with the
groove in the housing and slip
it
into
place. Snap the set plate back into place.
Be sure
to
close the set plate fully before
using the tool.
0
Do
not use force when inserting the battery cartridge.
If
the cartridge does not slide in easily,
it
is not being inserted correctly.
Charging
Plug the fast charger into your power
source. Insert the battery cartridge
so
that
the plus and minus terminals on the bat-
tery cartridge are on the same sides as their
respective markings on the fast charger.
Insert the cartridge fully into the port
so
that it rests on the charger port floor.
The charging light will come on and charg-
ing will begin.
If
the charging light does
not come
on,
press the reset button.
If
the
charging light goes
out
within
10
seconds
even after pressing the reset button a
couple
of
times, the battery cartridge is dead. (CAUTION
:
Wait
for
more than
5
seconds
after the charging light goes out
to
press the reset button again.) Replace
it
with a new
one. When the charging light goes
out
after about one hour, you may remove the fully
charged battery cartridge.
After charging, unplug the charger from the power source.
CAUTION
:
0
Your new battery cartridge is not charged. You will need
to
charge it before use.
0
If
you try
to
charge a cartridge from a just-operated tool, sometimes the charging light
will not come on.
If
this occurs, let the cartridge
cool
off
for
a while. Then re-insert
it
and try
to
charge
it
once more.
When you charge a new battery cartridge
or
a battery cartridge which has not been used
for
a long period, it may
not
accept a
full
charge. This is a normal condition and does
not
indicate a problem. You can recharge the battery cartridge fully after discharging
it almost completely a couple
of
times.
0
If
you wish to charge two battery cartridges, allow
15
minutes between chargings
on
the
fast charger.
6