Filter
Top Products
IMPORTANT
SAFETY
INSTRUCTIONS
(For
All
Tools)
WARNING:
WHEN USING ELECTRIC TOOLS, BASIC SAFETY
PRECAUTIONS SHOULD ALWAYS
BE
FOLLOWED
TO
REDUCE
THE
RISK
OF
FIRE,
ELECTRIC SHOCK, AND PERSONAL
INJURY,
INCLUDING THE FOLLOWING:
READ ALL INSTRUCTIONS.
1.
2.
3.
4.
5.
6.
7.
a.
9.
IO.
11.
12.
13.
2
KEEP WORK AREA CLEAN. Cluttered areas and benches invite injuries.
CONSIDER WORK AREA ENVIRONMENT. Don't use power tools in damp
or
wet locations. Keep work area well lit. Don't expose power tools to rain.
Don't
use
tool in presence of flammable liquids
or
gases.
KEEP CHILDREN AWAY. All visitors should be kept away from work area.
Don't let visitors contact tool
or
extension cord.
STORE IDLE TOOLS. When not in use, tools should be stored in dry, and high
or
locked-up place
-
out of reach of children.
DON'T FORCE TOOL. It
will
do the job better and safer at the rate for which
it
was intended.
USE
RIGHT TOOL. Don't force
small
tool
or
attachment to do the job
of
a
heavy-duty tool. Don't use tool
for
purpose not intended.
DRESS PROPERLY. Don't
wear
loose
clothing
or
jewelry. They can be caught
in moving parts. Rubber gloves and non-skid footwear are recommended
when
working
outdoors. Wear protective hair covering to contain long hair.
USE
SAFETY GLASSES. Also use face
or
dust mask if cutting operation
is
dusty.
DON'T ABUSE CORD. Never carry tool by cord
or
yank it to disconnect from
receptacle. Keep cord from heat,
oil,
and sharp edges.
SECURE WORK.
Use
clamps
or
a
vise to hold
work.
It's safer than using
your hand and it frees both hands
to
operate tool.
DON'T OVERREACH. Keep proper footing and balance at all times.
MAINTAIN
TOOLS
WITH CARE. Keep
tools
sharp and
clean
for better and
safer performance.
Follow
instructions for lubricating and changing acces-
sories.
Inspect tool cords periodically and if damaged, have repaired by autho-
rized service facility. Inspect extension cords periodically and replace if
damaged. Keep handles dry, clean, and free from
oil
and
grease.
DISCONNECT TOOLS. When not in use, before servicing, and when chang-
ing accessories, such as blades, bits, cutters.