Filter
Top Products
CAUTION:
The fast charger Model DC1201 is specifically designed to charge only Makita battery
cartridges. Never use
it
for other purposes or for other manufacturer's batteries.
When you charge a new battery cartridge or a battery cartridge which has not been used
for a long period of time,
it
may not accept a full charge. This is a normal condition and
does not indicate
a
problem. You can recharge the battery cartridge fully after discharging
it
completely and recharging a couple
of
times.
If you charge a battery cartridge from a just-operated tool or a battery cartridge which
has been left in
a
location exposed to direct sunlight or heat for a long time, the charging
light may flash in red color. If this occurs, wait for a while. Charging will begin after the
battery cartridge cools.
If
the charging light flashes alternately in green and red color and a tone sound "beep,
beep, beep,
..."
for about
20
seconds, a problem exists and charging is not possible. The
terminals on the charger or battery cartridge are clogged with dust or the battery cartridge
is worn out or damaged.
If you wish to charge two battery cartridges, allow 15 minutes between chargings on
the fast charger.
Adjusting the stopper plate
Loosen the bolts which secure the stopper
plate. Adjust the stopper plate in accordance
with the screw length as shown in the figure
below.
Fig. A-I
:
For screws 25 mm (1
"1
or 28 mm
(
1
-
1
18") long
Fig. A-2: For screws 32 mm (1
-1
14")
long
Fig. A-3: For screws
40
mm (1-9/16") long
Then tighten the bolts to secure the stopper
plate.
/---
Stopper
L.-----
Pins
/A
I
T
Pin
Fig.
A-I
Fig.
A-2
Fig.
A-3
NOTE:
As for Fig. A-2 and A-3, secure the stopper plate with both ends contacting the pins on
each side to keep the plate from tilting.
8