Filter
Top Products
Adjusting the driving depth
Depress the stopper plate as far as
it
will go.
While keeping
it
in this position, turn the
adjusting knob until the bit tip projects
approx.
5
mm
(3/16")
from the stopper plate.
Drive a trial screw.
If
the screw head projects
above the surface of the workpiece, turn the
adjusting knob
in
the Wdirection; if the
screw head is countersunk, turn the adjust-
ing knob
in
the
B
direction.
Approx.
5
mm
(3/16")
c
Casing
Stopper plate
Adjusting knob
Installing the screw strip
Insert the screw strip through the screw guide. Then insert
it
through the feeder box until
the first screw reaches the position next to the driving position.
Screw guide peder box
Driving position
Removing the screw strip
To remove the screw strip, just pull
it
out
in
the direction of the arrow.
9