Filter
Top Products
13
• Do not operate the tool without screws. It will damage
the driving surface.
• If the feeder box does not work smoothly when driving
screws, spray car wax (spray type) on the sliding
surfaces. Never lubricate it.
Driving in corner
This tool can be used to drive at a position 15 mm (5/8”)
away from the wall.
CAUTION:
• Driving at a position closer than 15 mm (5/8”) to the wall
or driving with the stopper base in contact with the wall
may damage the screw heads and cause wear on the
bit. This may also lead to poor fastening of screws and
malfunction of the tool.
MAINTENANCE
CAUTION:
• Always be sure that the tool is switched off and the
battery cartridge is removed before carrying out any
work on the tool.
To maintain product SAFETY and RELIABILITY, repairs, any
other maintenance or adjustment should be carried out by
Makita Authorized or Factory Service Centers, always using
Makita replacement parts.
EN0001-1
Recycling the Battery
The only way to dispose of a Makita battery is to recycle it.
The law prohibits any other method of disposal.
To recycle the battery:
1. Remove the battery from the tool.
2. a) Take the battery to your nearest Makita Factory Ser-
vice Center
or
b) Take the battery to your nearest Makita Authorized
Service Center or Distributor that has been desig-
nated as a Makita battery recycling location.
Call your nearest Makita Service Center or Distributor to
determine the location that provides Makita battery recycling.
See your local Yellow Pages under “Tools-Electric”.
1. Wall
2. Stopper base
001887
1
2
15mm(5/8”)
Ni-Cd