Filter
Top Products
9
Setting for desired screw length
There are 3 positive-lock screw length settings. To obtain the
desired setting, pull out the stopper base while depressing
the lever until you see the number of the desired screw
length (indicated on the plate) appear to rest on the very top
edge of the casing.
See the table below for the relation between the number indi-
cated on the plate and the respective screw length ranges.
Adjusting the driving depth
Depress the stopper base as far as it will go. While keeping it
in this position, turn the adjusting knob until the bit tip
projects approx. 5 mm (3/16”) from the stopper base. Drive a
trial screw. If the screw head projects above the driving sur-
face, turn the adjusting knob in the A direction; if the screw
head is countersunk, turn the adjusting knob in the B direc-
tion.
Switch action
CAUTION:
• Before inserting the battery cartridge into the tool,
always check to see that the switch trigger actuates
properly and returns to the “OFF” position when
released.
To start the tool, simply pull the switch trigger. Release the
switch trigger to stop.
1. Lever
2. Stopper base
3. Plate
4. Casing
001875
1
2
3
4
Number indicated on the plate
25 / 28
32
40
Screw length range
25 mm(1”) - 28 mm(1-1/8”)
28 mm(1-1/8”) - 35 mm(1-3/8”)
35 mm(1-3/8”) - 41 mm(1-5/8”)
1. Approx. 5 mm(3/16”)
2. Stopper base
3. Casing
4. Adjusting knob
001876
B
A
1
3
2
4
1. Switch trigger
001877
1