Filter
Top Products
ADDITIONAL SAFETY RULES FOR SANDER
1.
Check the backing pad carefully for cracks, damage or deformity before
2.
Hold the tool firmly.
3.
Keep hands away from rotating parts.
4.
Make sure abrasive disc is not contacting the workpiece before the switch
5.
Do not leave the tool running. Operate the tool only when hand-held.
6.
Do not touch the workpiece immediately after operation:
it
may be extremely
operation. Replace cracked, damaged or deformed pad immediately.
is turned on.
hot and could burn your skin.
ADDITIONAL SAFETY RULES FOR GRINDER
1.
Keep guards
in
place.
2.
Use only wheels having a maximum operating speed at least as high as
“No
Load
RPM”
marked on the tool’s nameplate. When using depressed center
wheels, be sure to use only fiberglass-reinforced wheels.
3.
Check the wheel carefully for cracks or damage before operation. Replace
cracked or damaged wheel immediately.
4.
Use only flanges specified for this tool.
5.
Be careful not to damage the spindle, the flange (especially the installing
surface) or the lock nut. Damage to these parts could result
in
wheel
breakage.
6.
Hold the tool firmly.
7.
Keep hands away from rotating parts.
8.
Make sure the wheel is not contacting the workpiece before the switch is
turned on.
9.
Before using the tool on an actual workpiece, let
it
run for a while. Watch
for vibration or wobbling that could indicate poor installation or a poorly
balanced wheel.
IO.
Use the specified surface of the wheel to perform the grinding.
11.
Watch out for flying sparks. Hold the tool
so
that sparks fly away from you
12.
Do not leave the tool running. Operate the tool only when hand-held.
13.
Do not touch the workpiece immediately after operation:
it
may be extremely
and other persons or flammable materials.
hot and could burn your skin.
SAVE
THESE
INSTRUCTIONS.
4