Filter
Top Products
Switch action
To
start the tool, simply pull the trigger.
Release
the trigger to stop. For continuous
operation, pull the trigger and then push in
the lock button.
To
stop the tool from the
locked position, pull the trigger fully, then
release
it.
CAUTION
:
Before plugging in the tool, always check to
see
that the trigger switch actuates properly
and returns to the
"OFF"
position when released.
Operation
Hold the tool firmly. Turn the tool on and
then apply the abrasive disc to the work-
piece. In general, keep the abrasive disc
at
an angle of about
15'
to the workpiece
surface. Apply slight pressure only. Exces-
sive
pressure will result in poor perform-
ance and premature wear to the abrasive
disc.
6