Filter
Top Products
IF
USED
AS
A
GRINDER
NOTE:
Use grinder accessories specified in this manual. These must be purchased by separate.
WARNING:
Always use guard assembly or accessory kit, noted below, for type 27 depressed center
wheel.
Guard assembly Guard accessory kit
Part
No.
191214-3.
. .
For 180 mm
(7")
Part No. 191215-1
.
. .
For 230 mm (9")
Part No. 191228-2
. .
.
For 180 mm
(7")
Part No. 191231-3
.
.
.
For 230 mm (9")
Installing or removing depressed center wheel
CAUTION
:
Always be sure that the tool
is
switched off and unplugged before installing or removing
the wheel.
Mount the inner flange onto the spindle.
Fit
the wheel on over the inner flange and
screw the lock nut onto the spindle.
Inner
flange
To
tighten the lock nut, press the shaft
lock firmly
so
that the spindle cannot re-
volve, then use the lock nut wrench and
securely tighten clockwise.
To remove the wheel, follow the installation procedure in reverse.
7