Filter
Top Products
6.
Cutting repetitive lengths
When cutting several pieces
of
stock to
the same length, ranging from
220
mm
(8-5/8") to 365 mm (14-3/8"), use of the
set plate (optional accessory) will facili-
tate more efficient operation. Install the
set plate on the holder as shown in the
figure. Align the cutting line on your
workpiece with either the left or right
side of the groove in the kerf board, and
while holding the workpiece from mov-
ing, move the set plate flush against the
end of the workpiece. Then secure the
set plate with the screw. When the set
plate is not used, loosen the screw and turn the set plate out of the way.
NOTE:
Use of the holder-rod assembly (optional accessory) allows cutting repetitive lengths,
ranging from
220
mm (8-518") to 2,230 mm
(7.3
ft.)
Carrying tool
Make sure that the battery cartridge is removed. Secure the blade at
0"
bevel angle and
the turn base
at
52"
miter angle to the right. Lower the handle fully and lock
it
in the
lowered position by pushing in the stopper pin. Carry the tool by the carrying grip as
shown in the figure below.
CAUTION:
*Always secure
all
moving portions before carrying the tool.
*Stopper pin is for carrying and storage purposes only and not for any cutting operations.
24