Filter
Top Products
When you charge
a
new battery cartridge or
a
battery cartridge which has not been used
for
a
long period of time, it may not accept
a
full charge. This is
a
normal condition and
does not indicate
a
problem. You can recharge the battery cartridge fully after discharging
it completely and recharging
a
couple of times.
If you charge
a
battery cartridge from
a
just-operated tool
or
a battery cartridge which has
been left in
a
location exposed
to
direct sunlight or heat for
a
long time, the charging light
may flash in red color. If this occurs,
wait
for
a
while. Charging will begin after the battery
cartridge cools. The battery cartridge will cool faster if you remove the battery cartridge
from the high capacity battery charger.
If the charging light flashes alternately in green and red color,
a
problem exists and charg-
ing is not possible. The terminals on the charger or battery cartridge are clogged with
dust or the battery cartridge
is
worn out or damaged.
Trickle charge (Maintenance charge)
If you leave the battery cartridge in the charger to prevent spontaneous discharging after
full charge, the charger will switch into its ”trickle charge (maintenance charge)” mode and
keep the battery cartridge fresh and fully charged.
Tips for maintaining maximum battery life
1.
Charge the battery cartridge before completely discharged.
Always stop tool operation and charge the battery cartridge when
you
notice less tool
power.
2.
Never recharge a fully charged battery cartridge.
Overcharging shortens the battery service life.
3.
Charge the battery cartridge with room temperature at
10°C
-
40°C
(50°F
-
104°F)
Let
a
hot battery cartridge cool down before charging it.
Installing auxiliary plate
Install the auxiliary plate using the notch in the tool‘s base and secure it by tightening the
hex. bolt.
Base
-zFTD
Hex bolt Auxiliary plate
Auxiliary plate Base
Hex
bolt
Nut
9