Filter
Top Products
Depth adjustment
If the staples
are
driven too deep or too
shallow, adjust the driving depth by turn-
ing the nut on the bottom of the tool. For
deeper driving of staples, turn the nut
clockwise. For shallower driving, turn the
nut counterclockwise. Please note the nut
must be turned in increments of
180"
(1/2
turn)
so
that the groove on the nut runs
parallel to the magazine.
NOTE
:
If the distance between the tool end (A)
and the material to be fastened
is
more
than
2
mm
(5/64"),
the tool will not
operate because the safety
lever
is
not
pressed enough to operate the tool.
Driving staples
Place the tool on the material to be fastened
so
that the front and the rear of the tool
contact the material flat. Do not tip the
tool
to
the right or left side. Hold the tool
firmly against the material. Then pull the
trigger to drive the
staples.
If the staples are driven too shallow, press
the tool head
as
shown in the figure and
drive the staples.
If the staples are still driven too shallow,
adjust the driving depth by turning the nut
clockwise. Refer to "Depth adjustment".
CAUTION:
Do not operate the tool without staples.
It
shortens the service
life
of the tool.
I
Nut
lk---?--
/
Tool
end
(A)
Material
-=-
2
mm
(5/64")
-
If the tool becomes jammed, do
as
follows. First, remove the battery cartridge. Open the
sub-magazine and remove the stuck staple using
a
screwdriver or the like.
10