Filter
Top Products
Installing or removing battery cartridge
Always switch off the tool before insertion
or
removal
of
the
battery cartridge.
.To
remove the battery cartridge, pull out
[
the
set
plate on the tool and grasp both
sides of the cartridge while withdrawing
it
from the tool.
*To
insert the battery cartridge, align the
tongue on the battery cartridge with the
Battery cartridge
Set plate
v
groove in the housing and slip
it
into
place. Snap the
set
plate back into place.
Be sure to close the
set
plate fully before
using the tool.
0
Do not use force when inserting the battery cartridge.
If the cartridge does not slide in easily,
it
is not being inserted correctly.
CAUTION
:
If
you
pull out the
set
plate carelessly when extra staples and stored in the storage space
in the tool, the extra staples can fall out and present
a
danger to anyone or anything
below. Always hold the tool with the
set
plate facing up to prevent the extra staples
from falling out when you pull out the
set
plate.
Charging
Plug the fast charger into your power
source. Insert the battery cartridge
so
that
the plus and minus terminals
on
the bat-
tery cartridge are on the same sides
as
their
respective markings on the fast charger.
Insert the cartridge fully into the port
so
that
it
rests
on the charger port floor.
Press the start button (red). The charging
light will come on and charging will begin.
If
the charging light does not come on,
press
the reset button (yellow) first, then
Charging light
Start button-
the start button (red). If the charging light goes out within
10
seconds even after pressing
the reset button and start button
a
couple of times, the battery cartridge
is
dead. (CAU-
TION:
Wait for more than
5
seconds after the charging light goes out to press the reset
button again.) Replace
it
with
a
new one. When the charging light goes out after about
one hour, you may remove the fully charged battery cartridge.
After charging, unplug the charger from the power source.
7