Filter
Top Products
ADDITIONAL SAFETY RULES
1.
Always wear safety goggles or safety glasses with side shield, and a full
face shield when needed.
2.
Do
not point the ejection port at anyone in the vicinity (especially his face).
Keep hands and feet away from the ejection port area.
3.
Always remove the battery cartridge before loading the staples, adjustment,
inspection, maintenance or after operation is over.
4.
Make sure no one is nearby before operation. Never attempt to drive staples
from both the inside and outside of wall at the same time. Staples may rip
through and/or fly off, presenting a grave danger.
5.
Watch your footing and maintain your balance with the tool. Make sure there
is no one below when working in high locations.
6.
Check walls, ceilings, floors, roofing and the like carefully to avoid possible
electrical shock, gas leakage, explosions, etc. caused by stapling into live
wires, conduits or gas pipes.
7.
Use only staples specified
in
this manual. The use of any other staples may
cause malfunction of the tool.
8.
Do
not tamper with the tool or attempt to use
it
for other than driving staples.
9.
Do
not operate the tool without staples.
It
shortens the service life of the tool.
IO.
Stop driving operations immediately
if
you notice something wrong or out
of the ordinary
with
the tool.
11.
Never staple into any materials which may allow the staple to puncture and
fly through as a projectile.
12.
Never actuate the trigger switch and safety lever at the same time
until
you
are prepared to staple workpieces. Allow the workpiece to depress the safety
lever. Never defeat its purpose
by
securing the safety lever back or
by
depressing
it
by hand.
13.
Never tamper
with
the safety lever. Check the safety lever frequently for
proper operations.
SAVE
THESE
INSTRUCTIONS.
6
,