Filter
Top Products
13
First, loosen the two wing nuts on the holder and insert the
blades (A) and (B), so that they contact the sides (C) and (D).
Then tighten the wing nuts.
Immerse the dressing stone in water for 2 or 3 minutes
before sharpening. Hold the holder so that the blades both
contact the dressing stone for simultaneous sharpening at
the same angle.
Replacing carbon brushes
Remove and check the carbon brushes regularly. Replace
when they wear down to the limit mark. Keep the carbon
brushes clean and free to slip in the holders. Both carbon
brushes should be replaced at the same time. Use only iden-
tical carbon brushes.
Use a screwdriver to remove the chip cover.
1. Wing nut
2. Blade (A)
3. Blade (B)
4. Side (D)
5. Side (C)
1
2
3
4
5
002589
002590
1. Limit mark
1
001145
1. Chip cover
2. Screwdriver
1
2
002597