Filter
Top Products
7
• Handle the blades very carefully. Use gloves or rags to
protect your fingers or hands when removing or installing
the blades.
• Use only the Makita wrench provided to remove or install
the blades. Failure to do so may result in overtightening
or insufficient tightening of the installation bolts. This
could cause an injury.
1. Remove the existing blade, if the tool has been in use,
carefully clean the drum surfaces and the drum cover. To
remove the blades on the drum, unscrew the three
installation bolts with the socket wrench. The drum cover
comes off together with the blades.
2. To install the blades, loosely attach the adjusting plate to
the set plate with the pan head screws and set the mini
planer blade on the gauge base so that the cutting edge
of the blade is perfectly flush with the inside flank of the
gauge plate.
3. Set the adjusting plate/set plate on the gauge base so
that the planer blade locating lugs on the set plate rest in
the mini planer blade groove, then press in the heel of
the adjusting plate flush with the back side of the gauge
base and tighten the pan head screws.
4. It is important that the blade sits flush with the inside
flank of the gauge plate, the planer blade locating lugs
sit in the blade groove and the heel of the adjusting plate
is flush with the back side of the gauge base. Check this
alignment carefully to ensure uniform cutting.
1. Socket wrench
2. Bolt
1
2
002564
1. Pan head screw
2. Adjust plate
3. Planer blade locating lugs
4. Gauge plate
5. Heel of adjust plate
6. Set plate
7. Inside flank of gauge plate
8. Gauge base
9. Back side of gauge base
10.Mini planer blade
1
2
3
4
5
6
7
8
9
10
002565