Filter
Top Products
11
• When using the straight guide, be sure to install it on the
right side in the feed direction. This will help to keep it
flush with the side of the workpiece.
Straight guide (optional accessory)
The straight guide is effectively used for straight cuts when
chamfering or grooving.
To install the straight guide, insert the guide bars into the
holes in the tool base. Adjust the distance between the bit
and the straight guide. At the desired distance, tighten the
hex socket bolts to secure the straight guide in place.
When cutting, move the tool with the straight guide flush with
the side of the workpiece.
If the distance between the side of the workpiece and the
cutting position is too wide for the straight guide, or if the side
of the workpiece is not straight, the straight guide cannot be
used. In this case, firmly clamp a straight board to the work-
piece and use it as a guide against the base. Feed the tool in
the direction of the arrow.
Templet guide (optional accessory)
The templet guide provides a sleeve through which the bit
passes, allowing use of the tool with templet patterns.
1. Hex socket bolts
2. Straight guide
1
2
003679
003685
003686
003690