7
FUNCTIONAL
DESCRIPTION
CAUTION:
• Always be sure that the tool is switched off and
unplugged before adjusting or checking function on the
tool.
Adjusting the depth of cut
Place the tool on a flat surface. Press the lock lever down
and lower the tool body until the bit just touches the flat sur-
face. Release the lock lever to hold the tool body down.
Turn the stopper pole setting nut counterclockwise to loosen.
While pressing the fast-feed button, lower the stopper pole
until it makes contact with the adjusting hex bolt. Align the
depth pointer with the “0” graduation. The depth of cut is indi-
cated on the scale by the depth pointer. While pressing the
fast-feed button, raise the stopper pole until the desired
depth of cut is obtained. Minute depth adjustments can be
obtained by turning the adjusting knob (1.6 mm (1/16”) per
turn). After adjusting the depth of cut, turn the stopper pole
setting nut clockwise to fasten the stopper pole firmly.
Now, your predetermined depth of cut can be obtained by
pressing the lock lever and then lowering the tool body until
the stopper pole makes contact with the adjusting hex bolt of
the stopper block.
Nylon nut
CAUTION:
• Do not lower the nylon nut too low or the bit will protrude
dangerously.
By turning the nylon nut, the upper limit of the tool body can
be adjusted. When the tip of the bit is retracted more than
required in relation to the base plate surface, turn the nylon
nut to lower the upper limit.
1. Lock lever
2. Adjusting knob
3. Depth pointer
4. Fast-feed button
5. Stopper pole
6. Fast-feed button
7. Stopper pole setting nut
1
2
3
4
7
6
5
003654
1. Nylon nut
1
003656