6
13.
Do not touch the bit immediately after
operation; it may be extremely hot and
could burn your skin.
14.
Always lead the power supply cord away
from the tool towards the rear.
15.
Do not smear the tool base carelessly with
thinner, gasoline, oil or the like. They may
cause cracks in the tool base.
16.
Draw attention to the need to use cutters
of the correct shank diameter and suitable
for the speed of the tool.
17.
Some material contains chemicals which
may be toxic. Take caution to prevent dust
inhalation and skin contact. Follow mate-
rial supplier safety data.
SAVE THESE INSTRUCTIONS
WARNING:
MISUSE or failure to follow the safety rules stated in this
instruction manual may cause serious personal injury.
SYMBOLS
USD101-2
The followings show the symbols used for tool.
V .......................volts
A.......................amperes
Hz .....................hertz
................alternating current
....................no load speed
.../min................revolutions or reciprocation per
minute
n
˚