Filter
Top Products
© 2000-2005 Router Technologies
All Rights Reserved
Note: Cross lines for locating and drilling holes are accurate. The illustration of subbase may vary
slightly in size and design, but is accurate enough for cutting the rubber spacer if required.
Page 28
Refer to pages 4,5,6, before using template
Additional Templates Available on Website
Router Raizer Access Hole
3/4" reference circle for drilling the
routers original subbase only. Table
mounted, drill 1/2" hole in table top.
.500" reference circle
for drilling table top or
insert plate.
1/2" = .500
Makita 3612 C/ 3612 BR
router mounting holes
Use this 6" scale to check accuracy when copied
Router table fence reference line
Drill .500" hole
through router
table insert plate
install #30 dust cover insert
into .500" hole and press flush
with top of insert plate
Router Raizer Access Hole
NOTE: This router requires a 3/4" pocket or use of 8" X 8"
black rubber spacer for router table installation. Pages 4,5,6.
Makita 3612 C/ 3612 BR
NOTE: This hole must be drilled 1/2" or .500"
for #30 dust cover insert to fit properly.