With the help of the following notes, minor faults in the performance of the ironer,
some of which may result from incorrect operation, can be put right without
contacting the Service Department.
,
Repair work to electrical equipment should only be carried out by a suitably
qualified person in accordance with local and national safety regulations.
Repairs and other work by unqualified persons could be dangerous. The
manufacturer cannot be held liable for unauthorised work.
Problem Possible cause Remedy
The ironer will not
operate.
There is no power to
the ironer.
Check whether
- the mains plug is plugged in and
switched on.
- the fuse or circuit breaker has
tripped.
Laundry does not
pass smoothly
through the roller.
The ironing cover is
dirty.
Wash the cover at 60°C using a
proprietary detergent.
Laundry does not
pass smoothly
through the roller.
There are calcium
deposits (from hard
water) or starch
residues on the
heater plate.
Remove these with household
washing up liquid or a suitable
proprietary cleaning agent.
Folds have formed in
the ironing cover.
The heater plate is
dirty (calcium
deposits).
Clean the heater plate with
household washing up liquid or a
suitable proprietary cleaning
agent.
The ironing cover is
very dirty.
Soiling. Wash the cover at 60°C using a
proprietary detergent.
The heater plate has
no contact pressure.
The emergency
release catch has
been pulled up.
Push the emergency release
catch down (see also "Power
cut").
Problem solving guide
27