Filter
Top Products
~
This ironer complies with all relevant
local and national safety requirements.
Unauthorised repairs could result in
unforeseen dangers for the user, for
which the Miele cannot accept liability.
Repairs should only be undertaken by a
Miele approved service technician.
Ensure current is not supplied to the
ironer until after maintenance or repair
work has been carried out.
~
Faulty components must only be
replaced by genuine Miele original
parts. The manufacturer can only
guarantee the safety of the appliance
when Miele replacement parts are
used.
~
The ironer is only completely
isolated from the electricity supply
when:
– it is switched off at the wall socket
and the plug is withdrawn, or
– it is switched off at the mains, or
– the mains fuse is disconnected, or
the screw-out fuse is removed (in
countries where this is applicable).
~
Do not damage, remove or bypass
the safety features, fixtures and control
elements of this ironer.
~
Any removable outer panels must be
in place, and all moving or electrical parts
shielded before the ironer is switched on.
~
This ironer may only be used in
mobile installations such as ships if a risk
assessment of the installation has been
carried out by a suitably qualified
engineer.
Correct use
~
When working with the ironer always
wear close fitting clothes. Wide sleeves,
apron strings, ties or scarves could be
taken in by the roller.
~
Remove any rings, bracelets, or
other jewellery before starting to work.
Tie back long hair.
~
When heated up there is an acute
risk of burning:
–
if the heater plate is touched,
–
if the foot pedal is pressed down
while fingers or hands are positioned
between the raised heater plate and
the roller.
~
This ironer is not a toy! To avoild the
risk of injury do not let children play on
or near it, or with the controls.
Supervise children whilst you are using
it.
~
Do not drape laundry over the
heater plate when it is heated up. This
is a fire hazard.
~
Use the swing out bar.
It is designed for hanging laundry on.
After use it should be swung back out
of the way. Take care not to press down
on the bar when it is swung out. There
is a danger that this could tip the ironer
over.
~
Switch the ironer off before
removing the plug from the socket.
~
Do not pull it by the cable.
Warning and safety instructions
5