Filter
Top Products
Switching on
^
The control for the burner required must be pressed in and
turned anti-clockwise to the largest flame symbol to switch
on.
Pressing a burner control will automatically create a spark
on all burners. This is normal and no cause for concern.
^
When the flame ignites, keep the control pressed in for
8-10 seconds, and then let it go.
^
If the flame goes out prematurely, turn the control to "ß".
Wait for at least one minute before trying again. If
necessary keep the control pressed in for longer.
^ If the burner does not ignite the second time, turn the
control to "ß", and see "Problem solving guide".
In the event of a power cut
If there is an interruption to the electricity supply the gas can
be ignited with a match.
^ Press in the relevant control and turn it anti-clockwise to the
largest flame symbol.
^ Hold the control pressed in and light the burner with a
match.
^
Keep the control pressed in for a further 8-10 seconds and
then release it.
Operation
20