Filter
Top Products
. A complete Parts List is available at www.MillerWelds.com
OM-1327 Page 19
3-12. Installing Wire Spool and Adjusting Hub Tension
Ref. 805 023-A
When a slight force is needed to turn spool, tension is set.
15/16 in.
Use compression spring with
8 in (200 mm) spools.
Tools Needed:
3-13. Electrical Service Guide
Failure to follow these electrical service guide recommendations could create an electric shock or fire hazard. These
recommendations are for a dedicated branch circuit sized for the rated output and duty cycle of the welding power source.
60 Hz Single Phase 60 Hz Three Phase
Input Voltage (V) 200 230 460 575 200 230 460 575
Input Amperes (A) At Rated Output 69 61 30 24 34 30 15 12
Max Recommended Standard Fuse Rating In Amperes
1
Time-Delay Fuses
2
80 70 35 25 40 35 15 10
Normal Operating Fuses
3
100 90 40 35 50 45 20 15
Min Input Conductor Size In AWG
4
6 8 10 12 10 10 14 14
Max Recommended Input Conductor Length In Feet (Meters)
101
(31)
86
(26)
229
(70)
217
(66)
86
(26)
114
(35)
178
(54)
227
(85)
Min Grounding Conductor Size In AWG
4
8 8 10 12 10 10 14 14
Reference: 2008 National Electrical Code (NEC) (including article 630)
1 If a circuit breaker is used in place of a fuse, choose a circuit breaker with time-current curves comparable to the recommended fuse.
2 “Time-Delay” fuses are UL class “RK5” . See UL 248.
3 “Normal Operating” (general purpose - no intentional delay) fuses are UL class “K5” (up to and including 60 amps), and UL class “H” ( 65 amps and
above).
4 Conductor data in this section specifies conductor size (excluding flexible cord or cable) between the panelboard and the equipment per NEC Table
310.16. If a flexible cord or cable is used, minimum conductor size may increase. See NEC Table 400.5(A) for flexible cord and cable requirements.
NOTICE − This unit is either a 200/230/460 ac input voltage model or 460/575 ac input voltage model. See rating label on unit and check voltage
available at site to be sure it matches the voltage specified on the rating label.