Miller Electric Big Blue 452P Welding System User Manual


 
OM-496 Page 10
Return To Table Of Contents
3/96
1 Warning! Watch Out! There
are possible hazards as
shown by the symbols.
2 Do not smoke and keep
matches and flames away from
battery.
3 Sparks can cause battery
gases to explode. Battery
explosion can blind and injure.
Wear a face shield.
4 Battery acid can burn skin. Do
not spill acid.
5 Read Owner’s Manual.
6 Wear rubber gloves.
7 Dead battery
8 Engine block
9 Fully charged battery
10 Do not connect last negative
cable to dead battery − connect
instead to engine block.
11 Jumper cables − observe
polarity and make connections
in numbered sequence shown.
12 Once dead battery is charged,
disconnect cables in sequence
shown.
1
S-176 108
+−
+−
1
4
2
3
+
+−
+−
4
1
3
2
2 3 4 5 6
10
11
7
89 12
S-176 106
3/96
1 Warning! Watch Out! There
are possible hazards as
shown by the symbols.
2 Moving parts, such as fans,
rotors, and belts, can cut
fingers and hands and cause
injury. Keep away from moving
parts.
1
2
Starting Aid Switch. Below 32°F (0°C),
push switch up for 60 seconds before
starting engine.
Starting Instructions:
1 Press and hold Magnetic
Shutdown switch.
2 Turn Engine Control switch to
Start position.
3 Release Engine Control switch
and Starting Aid switch (if used)
when engine starts.
4 Continue holding Magnetic
Shutdown switch for 3 seconds
after engine starts.