Filter
Top Products
. A complete Parts List is available at www.MillerWelds.com
OM-4434 Page 38
8-7. Overload Protection (Robin-Powered Units)
803 848-C
! Stop engine. Disconnect
negative (−) battery cable.
1 Fuse F1 (See Section 11-1)
F1 protects the weld excitation
winding from overload. If F1 opens,
weld output stops or is low.
2 Fuse F2 (See Section 11-1)
F2 protects the generator power
excitation winding from overload. If
F2 opens, generator power output
stops or is low.
3 Fuse F6 (See Section 11-1)
F6 protects the engine wiring sys-
tem from overload. If F6 opens,
engine will not crank.
Replace any open fuses. Reinstall
cover before operating.
NOTICE − If a fuse opens, it usually
indicates a more serious problem
exists. Contact a Factory Autho-
rized Service Agent.
3/8 in
3
Tools Needed:
21
. Fuses F1, F2 located on
bracket behind left side
panel.
. Fuse F6 located in
harness behind left
side door.
Notes
16 Gauge (.063 in)
22 Gauge (.031 in)
24 Gauge (.025 in)
20 Gauge (.037 in)
18 Gauge (.050 in)
14 Gauge (.078 in)
1/8 in (.125 in)
3/16 in (.188 in)
1/4 in (.25 in)
5/16 in (.313 in)
3/8 in (.375 in)
1/2 in (.5 in)
MATERIAL THICKNESS REFERENCE CHART