Miller Electric MC-80 Work Light User Manual


 
OM-1592 Page 3
SECTION 3 INSTALLATION
3-1. Installing Hand-Held Torch
ELECTRIC SHOCK can kill.
Do not touch live electrical parts.
Turn Off cutter, and disconnect input power before
installing torch.
MOVING PARTS can cause injury.
Keep away from moving parts.
HOT PARTS can cause severe burns.
Allow cooling period before maintaining or servicing.
WARNING
swarn8.1* 10/91
Turn Off cutter and remove input
power. Remove top of cutter case.
1 Trigger Switch Connector
2 Gas Hose Connector
3 Pilot Lead Terminal
4 Boot
Insert hose and leads through boot.
5 Gas Hose
6 Pilot Terminal
Connect hose and leads as shown.
Reinstall top of case.
Ref. ST-800 895 / ST-800 896
3/8, 5/8 in
Tools Needed:
4
512
6
4
32
1
Rear Panel
Significant DC voltage can remain on capacitors in cutter
after unit is Off. Always discharge capacitors according to
cutters Owners Manual before installing torch.
Figure 3-1. Installing Hand-Held Torch Into Cutter