Filter
Top Products
OM-197 509 Page 13
SECTION 4 – OPERATION
4-1. Pendant Controls
Controls are pendant mounted. An optional
remote pendant extension cord is available.
1 Nameplate
Pendant has three nameplates stacked one
on top of the other. Each nameplate contains
the voltage and amperage range for a differ-
ent size flux cored welding wire (for reference
only).
Unit is shipped with 1.2 mm wire nameplate
on top. See Section 3-10 to change to 1.4 mm
or 1.6 mm flux cored welding wire nameplate.
2 Voltage Control
Use control to set welding power source volt-
age at the wire feeder. Numbers are for refer-
ence only.
3 Wire Speed Control
Use control to adjust wire feed speed from 0
to 20 meters per minute.
.Match colored bands on voltage and wire
speed controls to get an acceptable
welding condition.
4 Jog Switch
Use Jog switch to momentarily feed welding
wire at speed set on Wire Speed control with-
out energizing welding circuit or shielding gas
valve.
Ref. ST-802 483-A / ST-199 348 / ST-199 350 / 199 343
2
4
3
1
Use Nameplates As A Voltage And Amperage Reference Only.