Filter
Top Products
. A complete Parts List is available at www.MillerWelds.com
OM-230 693 Page 14
4-6. Connecting Spoolmatic) 15A Or 30A Gun
804 910-A
1 Gun Trigger Plug
Insert plug into receptacle, and
tighten threaded collar.
2 Weld Cable
3 Shielding Gas Hose
Route weld cable through opening
in front panel.
Route gas hose along side panel.
4 Positive Weld Output Terminal
Connect weld cable to weld output
terminal.
5 Regulator/Flowmeter
Route shielding gas hose up to
regulator/flowmeter. Connect gas
hose to fitting on regulator/flowme-
ter.
. Two welding guns may be
connected to the welding
power source at the same time,
but only one welding gun may
be in use at any one time. If the
triggers of both welding guns
are pulled at the same time, the
weld output and wirefeed motor
are disabled.
Tools Needed:
3/4, 5/8 in
5
3
4
1
3
2