Filter
Top Products
MQ-WHITEMAN FS2/FS2SP CONCRETE SAW — PARTS & OPERATION MANUAL — REV. #2 (06/26/06) — PAGE 25
3. Check V-belt tension (Figure 18) by using a tensionmeter
(6.0 - 9.0 lbs.) against the inside belt at a mid point between
the two pulleys, or by deflecting the center belt at a mid point
3/8” (10 mm) - 1/2” (13 mm).
Figure 18. V-Belt Tension
4.
DO NOT over or under tension the V-belts. Severe damage
can occur to the saw and engine crank shaft if the belts are
over tensioned. A decrease of power to the blade and poor
performance will result if the belts are under tensioned (loose
on pulleys).
5. If the V-belts becomes worn or loose, replace them by using
the following V-belt part numbers listed in Table 6.
syelluPdnastleB-V.6elbaT
eziSenignEN/PtleB-VN/PyelluPeziSedalB
enignEPH31-5.8
)4(280510245141
)4(942311245102
enignEPH02
)4(798515635141
)4(280516635102
FS2/FS2SP CONCRETE SAW — INSPECTION -GUARDS, COVERS & BELTS
FS2/FS2SP CONCRETE SAW — INSPECTION -GUARDS, COVERS & BELTS