Filter
Top Products
PAGE 18 — MQ-WHITEMAN FS3SP CONCRETE SAW — PARTS & OPERATION MANUAL — REV. #0 (07/15/02)
FS3SP CONCRETE SAW — ENGINE COMPONENTS
4. Engine Oil – (See figure 7)
A. Engine Oil Dip Stick
■
Remove the dipstick and wipe clean.
■
Fully insert the dipstick; Then remove it to check
the oil level.
B. Engine Oil Limits
■
Check Oil Level. If the level is low, fill to the upper
limit mark on the dipstick with the recommended
oil.
■
Reinstall the dipstick and screw the oil filter cap
securely.
C. Engine Oil Filler and Cap.
Ensure that the mouth of the oil filler is kept clean
and that the cap is secure after servicing.
D. Engine Drain Bolt.
■
Drain the used oil while the engine is still warm.
Place suitable container to catch the used oil
before removing the Engine Drain Bolt.
■
Allow used oil to drain completely and then
reinstall oil drain bolt and tightly secure.
■
Refer to "A. & B." above for Oil Refil.
Dispose of used motor oil in a manner that is
compatible with the environment and the Local,
State, & Federal laws.
NOTICE
5. Electric Starter – Engine Start is electrically actuated by
12 Volt DC system. Starter button, choke, Throttle Handle,
and Engine On/Off Switches are conveniently located
on the operating console. (See figure 5)
6. Oil Filter – A "Spin On/Off" type oil filter is utilized. It is
recommended that the filter be replaced every (year / or
200 hours of operation). Oil Filter tightening torque is
approximately 16 ft-lb. (22 N-m, 2.2 kg-m)
Use only genuine Honda filters or a filter of equivalent
quality which is specified by the engine model. Using the
wrong filter, or a non-Honda quality equivalent, may
cause engine damage.
7. Muffler – A high-mount muffler (type "8") is utilized to
reduce noise and emissions; as well as deflect engine
exhaust away from the operator.
Engine components can generate extreme
heat. To prevent burns, do not touch these
areas while the engine is running or
immediately after operations. Never operate
the engine with the muffler removed.
NOTICE
WARNING
Figure 7. Engine Controls and Components