Filter
Top Products
PAGE 26 — MQ-MIKASA MRH-800DS VIBRATION ROLLER — PARTS & OPERATION MANUAL — REV. #3 (02/02/05)
Parking
Brake
(Released
Position)
Figure 20. Parking Brake
TRAVELING
1. Before starting to travel, make sure to release parking brake
located on the left side of the rear roller. If the parking brake
lever is tight, moving the roller back and forth will make it
easier (Figure 20).
MRH-800DS—OPERATION
VIBRATING
1. Shift the vibration lever AWAY from its OFF position. The
vibration lever will automatically spring forward and the
roller will start vibrating (Figure 21).
DO NOT reduce speed during work. When
shifting travel lever from forward to reverse,
be sure to stop the lever at the neutral
position first before moving the lever to the
opposite direction. DO NOT shift the lever
from forward to reverse (or reverse to
forward) in one motion.
CAUTION :
After test travel, shut down engine and
check for any problems including oil
leakage. If any trouble is found, correct the
problem before attempting to operate the
roller again.
CAUTION :
Using vibration with clutch slipping causes
the clutch to burn. Also, vibration should
NOT be used over completely compacted
area, paved road surface, or with stationary
roller.
CAUTION :
WATERING
1. For watering work, turn the water cocks clockwise, at the
rear of the machine, to start sprinkling. (Figure 22).
Figure 22. Water Cocks
Watercock
for Rear
Drum
Watercock
for Front
Drum
Figure 21. Vibration Lever
Off Position of
Vibration Lever
2. With the throttle lever in the RUN position, increase
the engine rotation.
3. Push the travel lever forward slightly. This will cause
the roller to travel forward at slow speed.
4. To increase the travel speed, push the travel lever
further.
5. Travel speed can be varied between 0 and 3 km/h
(both forward and reverse).
6. Push the travel lever backward to go in the reverse
direction.