Filter
Top Products
49
5. Loosen the Mounting Bolt and remove the Outer Collar and Bushing.
6. Inspect the Inner Collar to ensure the proper seating of the tapered fit.
♦ The Inner Collar should be seated between .030” and 0.0” (flush) to the
end of the Blade Shaft.
Fig. 31 — Proper seating of the Inner Collar on the Blade Shaft
7. Test to ensure that the Inner Collar does not wobble when rotated. Use an
indicator dial on the face of the Collar. Maximum tolerance is .003” run out
on the face of the Collar.
Inner Collar
Blade Shaft