Filter
Top Products
Ver: 10/14/2004 4
Removal of strips from Tool
1) Move the feed lever over slightly, and then press on the end of the feed latch as in
photo 3.
2) Move the feed lever back so it no longer centers the fastener as in Photo 4 and
release the feed latch. This frees the screw from the feed latch.
3) Then, pull the strip towards you and then out of the tool as shown in Photo 5. This
action will push over the strip tensioner spring to allow the strip to be removed easily.
It should be noted that
fasteners with large
heads
might not
directly latch into the
screw guide easily. If
this happens, push the
feed lever over with
your finger while
inserting the strip of
screws to latch the
first screw before
using.
3
1
2