Filter
Top Products
Ver: 10/14/2004 8
Changing the Hex Bit
The Hex bits are designed for specific screw guns such as the MK6827/HITACHI W8VB
screwdrivers. To change or insert the Hex bit, first cycle the tool against a table, use the Hex
bit change tool to hold the tool in the fully actuated position, ensure it is secure and cannot
spring out (Photo 7). Slide the Hex bit into the tool so that the shank sticks fully out of the
bottom. The Bit-retaining clip can then be attached or removed. Place the clip in the groove
and the clip against the edge of a table. Push slowly and firmly to engage clip. This clip is
important as is prevents the hex bit from accidentally hitting the feed latch, as well as
reducing problems if the bit happens to stick to a screw. Please insure that it always installed
on the bit before use. Carefully cycle the tool against table again to remove the bit change
tool to prevent damage.
Changing the Hex Bit – Cont’d
The Bit-Retaining clip is
important as is prevents the
hex bit from accidentally
hitt
ing the feed latch, as well
as reducing problems if the
bit happens to stick to a
screw. Please insure that it
always installed on the Hex
bit before use. The adaptor
assembly is only used with
the Square and Phillips bits.
Putting Bit clip on
taking Bit clip off
7