Filter
Top Products
3
-Do not drape cables over or around your body.
-Wear a full coverage helmet with shade (see ANSI Z87.1 safety standard) and safety glasses while welding.
-Wear proper gloves and protective clothing to prevent your skin from being exposed to hot metals, UV and IR
rays.
-Do not overuse or overheat your welder. Allow proper cooling time between duty cycles.
-Keep hands and fingers away from moving parts and stay away from the drive rolls.
-Do not point MIG gun at any body part of yourself or anyone else.
-Always use this welder in the rated duty cycle to prevent excessive heat and failure.
1.4 Specific Areas of Danger, Caution or Warning
1.4A Electrical Shock
Electric arc welders can produce a shock that can cause injury or death. Touching electrically
live parts can cause fatal shocks and severe burns. While welding, all metal components connected
to the wire are electrically hot. Poor ground connections are a hazard, so secure the ground lead
before welding.
-Wear dry protective apparel: coat, shirt, gloves and insulated footwear.
-Insulate yourself from the work piece. Avoid contacting the work piece or ground.
- Do not attempt to repair or maintain the welder while the power is on.
-Inspect all cables and cords for any exposed wire and replace immediately.
-Use recommended replacement cables and cords.
-Always attach ground clamp to the work piece work table as close to the weld area as possible.
-Do not touch the welding wire and the ground or grounded work piece at the same time.
-Do not use a welder to thaw frozen pipes.
1.4B Fumes and Gases
-Fumes emitted from the welding process displace clean air and can result in injury or death.
-Do not breathe in fumes emitted by the welding process. Make sure your breathing air is clean
and safe.
-Work only in a well-ventilated area or use a ventilation device to remove welding fumes from the
environment where you will be working.
-Do not weld on coated materials (galvanized, cadmium plated or containing zinc, mercury or barium). They
will emit harmful fumes that are dangerous to breathe. If necessary use a ventilator, respirator with air supply or
remove the coating from the material in the weld area.
-The fumes emitted from some metals when heated are extremely toxic. Refer to the material safety data sheet for
the manufacturer’s instructions.
-Do not weld near materials that will emit toxic fumes when heated. Vapors from cleaners, sprays and degreasers
can be highly toxic when heated.