Filter
Top Products
11
Figure 8: Guide-A-Cut Assembly
Water Curtain Assembly:
Remove the Water Curtain from the Saw Water Pan. Attach the Water Curtain Spring Clips
to the Pivoting Bar Located Under the Cutting Head. Note that the rough side of the Water
Curtain should face towards the front of the saw. The Water Curtain material is made is
designed to be easy to clean. To clean simply rinse the Water Curtain with water until
clean. The Water Curtain should be used when wet cutting to reduce the amount of debris
thrown from the blade and cutting surface. When dry cutting the Water Curtain can be
removed to allow the dust particles to drift away from the Saw Operator. See Figure 9:
Water Curtain Assembly.
Figure 9: Splash Guard Assembly
Wrenches:
Remove the 19mm and 22mm Wrenches from the plastic bag. Place the Wrenches in the
Wrench Holder Slots located in the rear of the machine see Figure10: Wrench
Placement.
Attach Splash Guard Here