Filter
Top Products
4
4
ontoXe
2-3 to
get
an effective seal.
sensor as shown in Figure
I
Correctly orient the ferrule
’
I
comtxession nut first.comoression nut and ferrule onto the sensor.
u
FLOW
Figure
2-2.
Insertion Mounting Details
2. Remove the compression fitting from the sensor and screw it into the pipe tee
(or reducer, if used).
3. Electrically connect sensor to analyzer. Refer to analyzer instruction manual
for details.
4. Calibrate analyzer using procedure in analyzer instruction manual.
5. After calibration, mount the sensor into the tee:
A. Place
3/4” NPT
TREADED TEE
DIMENSIONS mm
(in)
i/2
OR
FIrrING
3/4
COMPRESSION
l/2
OR
FT)
CLEARANCE
SENSOR
FOR SENSOR
(‘x
to 2 inch) and material into the process
pipe. If necessary, screw a respectively-sized reducer into the pipe tee.
avoid
leaks.
Recommendation:
Use
Teflon tape or pipe
sealant with Teflon. (Exception: For higher temperature
solutions, sealing with Teflon tape may not be adequate.)
SENSOR CABLE
6.1 M (20
-
Installation
1. Install a pipe tee of appropriate size
-
CDE681 Part 2
m
2:14
PM Page 4
7/17/03
M3594-0603-CDE681Series.qxd