Filter
Top Products
The following items are required to properly install
the OMEGA FP-6000 Series Adjustable Brass flow
sensor.
3.1 Hardware, Standard Sensor
• female pipe fitting (weld-on or saddle)
1
1
/
2
in. NPT or ISO 7/1-Rc 1-1/2
•1
1
/
4
in. (32 mm) diameter drill
• Pipe thread sealant
• Tape measure
3.2 Hardware, Hot-Tap Sensor
The Hot-Tap sensor requires all the above items
plus:
•Hot-Tap drilling machine (e.g. Mueller drilling
machine or equivalent)
• Female ball or gate valve (full port only)
1
1
/
2
in. NPT or ISO 7/1-Rc 1-1/2
• Male pipe nipple, 1
1
/
2
x 2 in./32 x 50 mm
1
1
/
2
in. NPT or ISO 7/1-R 1
1
/
2
•Hot-Tap installation tool (purchased separately)
3.3 Standard Fitting Installation
1. Depressurize and drain pipe.
2. Wearing safety face protection, drill a 1
1
/
4
in.
(32 mm) diameter hole in the pipe.
3. Install the pipe fitting on the outside of the pipe
according to the manufacturer's instructions.
Failure to follow these instructions may result in
bodily injury and/or product failure.
4
Chapter 3
Installation
Caution: Depressurize and
drain pipe before drilling .